Measurement Specialties 9116 Instrukcja Użytkownika Pobierz pdf (Strona 50)

Measurement Specialties Inc. Model 9116 User’s Manual

Page 38 www.MEAS-SPEC.com

Command ‘C’— Sub-command Index 03: Abort Multi-Point Calibration

This sub-command has no additional parameters.

Command

“C 03”

‘C’ is the command letter.

‘03’ is the sub-command index (ii) for Abort.

NOTE: all parameters are separated by a space.

Response

“A”

‘A’ is the acknowledge letter

Description: Aborts the Multi-Point Calibration function, if it is currently in progress. This

sub-command also restores the original “A/D samples for averaging” count to the

module that was in use before the calibration function was started.

It should be noted that executing the Configure & Start (‘00’) sub-command

again, after the calibration function has started collecting data (per Collect Data

(‘01’) sub-commands), but before the final data are calculated (per Calculate &

Apply (‘02’) sub-command), will have the same affect as this Abort function.

Example:

● Abort the Multi-Point Calibration function previously started

“C 03”

Read response:

“A”

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 145 146

Brak uwag

Measurement Specialties 9116 Instrukcja Użytkownika Strona 50